TO INSERT A FILM LOOP:
Install the loop with proper orientation to maximize loop life,
see BOTTOM VIEW diagram below
1. Place the Lower Roller E inside the Film Loop.
2. Locate the Lower Roller E in its slots F on the bottom of the Loop Carrier Frame D.
3. Draw the Film Loop towards the top of the Loop Carrier Frame D.
4. Insert the Upper Roller into the Film Loop, with the Motor on the right hand side.
* Careful the brass end stops don’t catch on any Film Loop image details.
5. Lower the Upper Roller and Motor Assembly into retainer slots, ensuring the Motor
Locating Pin G is on the top.
6. Lower the Loop Tension Door B onto the loop gently.
7. Lower the Top Hatch A.
8. Apply power to the Film/FX™ machine to check that the Film Loop moves correctly.
9. Insert into the iris slot of the appropriate fixture and focus as required.
10. Direction can be reversed by changing the position of the GAM Film/FX™
in the drop-in iris slot of your light.
Page 1 of 1
Unit Closed
C
Upper Roller in retainer slots
Lower Roller in retainer slots
E
Top Hatch Opened
D
B
Top Hatch
Loop Tension Door closed
Loop Carrier Frame
A
Top Hatch and Loop Tension Door Opened
F
B
Loop Tension Door in up position
Upper Roller ready for removal
Slots for positioning Lower Roller
CC
Slotted guide roller
Brass end-stops
Upper roller assembly
must be fully seated in
retainer slots
FX/LOOP
Motor locating pin
facing up
Loop Carrier Frame showing
retainer slots
Gearbox
Motor
G
C
TOP VIEW DETAIL
Motor
FX/Loop
TSLGAM-2 Fire/Waves
Lower Roller
Tension Door Roller
TOP VIEW
TO REMOVE A FILM LOOP:
1. Place GAM Film/FX™ loop machine into a level surface
with the Motor on the right hand side.
2. Lift the top Hatch Cover A up until it springs upwards.
3. Lift the Loop Tension Door B upwards until it springs open.
4. Lift the Motor and Upper Roller C forward out of the
Loop Carrier Frame D and slide out from inside the Film
Loop. (left to right).
* Careful the brass end stops don’t catch on any
Film Loop image details.
5. The Lower Roller will slip out of its locating slots as the
Film Loop is removed.
IMPORTANT TIPS
FOR USING THE GAM FILM/FX™
It is important to smooth focus the field of the ellipsoidal spotlight be-
fore inserting the Film/FX™ into the gate. Hot spots will cause uneven
wear on the FX/Loop and shorten its useful life. Be sure that the field is
as even as possible with no hot center. Always have the FX/ Loop in
motion before the light comes on. Do not allow the section to heat up
and shorten the life of the loop particularly if excessive heat is focused
on one area.
Welded
Seam on
FX/Loop
Lower Roller
Side View of
Welded Seam Overlap
Loop
Direction
Loop
Direction
Top of
Overlap
Bottom
of Overlap
BOTTOM VIEW
PRODUCT INSTRUCTIONS
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels